DRAWZILLA

Larry, my wife Penny does all my measurements and gathering up all the information along with about 200 pictures and I'm good to go. Sometimes I will have a question, but the photos will most of the time tell me what I need. She will also crawl into an attic and take photos. She is a lot more limber than I.

to find out the layer of anything, just select it and open it and go to the layer tab to see where it's kept or change it to any layer you want. Or you can select anything and look at the bottom of the screen and see what layer it's on without having to open anything.

Sorry, i don't get into anything more than 3 stories, but they can be detailed. I never do any commercial either. Not sure how chief would handle that.

I have a 3060 24 gb, and it works just fine for me

@Joe_CarrickJoe, do you see any problems moving to X15 when it's ready, is there any changes needed with your system. Thanks

what really matters is that I add all the square footages for my square footage price. For the cities, it might differ from that depending on the city, I usually have to check with them. 50 different cities are too much especially when they change constantly and often, even amongst different plan checkers in the same city

Joe, all I have to say is "wow", this is perfect for me. you have done a lot of work on this. thanks

that's a new one for me so far, hope it never happens around here

i have been going to the outside of the stud wall-no finish, and have been forever, the cities seem to allow it.

sometimes errant line will go away when you actually print it.

you have to import a page at a time

the roof plane cannot go past the outside of the stucco or problems will happen, so just pull the roof plane back to the outside of the stucco

thank you, sir, you are always there, and we are better off for that.

Does anyone have the fix-it list for yesterday's update to x14. I usually forget to get that.

I have almost your same setup and no slowness, but it all depends what kind of projects you have going on and what's in them

ok I'm in!!!

I use carbonite without any slow problems, but I think it might be that I have a gig speed internet

WOW GOOD LUCK WITH THAT, mine is basic with the most used tools

I really \like my Streamdeck 32 although I'm sure it not as extensive as yours. Never liked using hotkeys

audio was fine for me

I would just open the old plan in the newest version and repair as needed, I do it all the time. Or trace the old plan in the newest version. I just can't go back; my mind is set for the newest.

I do mono slabs all the time and they look pretty good; I think you just need to learn more about it. There is almost always some sort of manually adjusting after auto building to get it the way you want. One hint I use is to put a room label on each room of the foundation with the floor height listed so I can look instantly and see if the height is correct. I noticed the interior footings are not in your chief generated plan, you just have to check the box to have a footing in the wall DBX. and it will auto generate when you build the foundation or it's very easy to add them manually.

Tool heck with the texture, where can I get that house for 229,000.

just add a sand pattern to your stucco material, it will show in vector views

Add a sand fill to the stucco material