DRAWZILLA

I have always used live views for everything, I really don't want to guess if things are updated or not. If you need to fix or add lines , do it on the live view, not on the layout.

I would move the walls first, then add the window. The reason the window disappears is that you are moving the wall after.

yes it's new this year, they measure the drop-off differently

I noticed you have an unusual amount of plan views open at the same time, you could try and close most of them and see if that helps.

I'm sometimes run into this, what gets me through is I tell them I do not have an electrician yet and can have him come in for the electrical permit at a later time with the electrical .loads done by a licensed electrician. And you really don't want me doing it.

I actually liked the Aerial view tool, tooo bad its gone

wow I haven't seen those type of codes in years I have a size 15 foot and I couldn't even fit my foot on a minimum tread in your state, remind me not to go there.

THAT WALL MIGHT BE REGENERATING automatically with auto attic walls turned on, you might not want to delete it just turn attic walls off in final view sent to the layout.

open the walls dbx and uncheck attic wall then delete it or turn off attic walls

I haven't noticed that, thanks, they snuck it in.

ditto

my grandkids all want to be hardwired in for major gaming, one kid has a much better computer system than me. wi-fi is just too slow even on a 1 gb plan.

You can also set a lot of things up by setting the rooms up in the default rooms dbx. set up a shower room, no moldings, tile floor. etc. Then just name the room and done

adjust the shower wall exactly how you want it ,then save the wall to the lib. for future use. The materials can always be changed later.

all I know , it didn't work for me. so I had to buy a second 4k monitor

Make sure you don't mix resolutions with different monitors 1080p or 4k for all, but don't mix or it will not let the lower resolution go full screen

you could try a material list polyline

Could be a lot of reasons for slowness, call tech support and they can help you better than guessing what it might be.

I had this problem when I got a new 4k monitor with a different resolution. I did have to change each one by opening and closing. It happened mainly to blocked cad details and not unblocked text. That's why templates are important you only need to fix it once. This has happened to me a few times over the 15+ years I have been with Chief.

it's going to be over 90 d here today

here is a list of some standard California changes I put on every plan 2019 min const standards.zip

Lets hope everyone doesn't go out for a hot dog.

MINE INSTALLED OK

Scott, there are no cruises to Alaska this year

very nice method, Rod