joey_martin

I had to do the same. Completely removed my user catalog, went back to X14 and cleaned it up a bit and exported it, re-loaded in X15 and I'm all good so far.

@Eric_S there is no "thumbnail", though preview allowed me to get a little farther. When I click to open the User Catalog folder to see all my folders it hangs up again.

I will need to try this as well, if I can get to that point...

Turn off the view window label.

https://hometalk.chiefarchitect.com/gallery/image/481-columns-and-pillars/ Columns and Pillars library also.. https://www.chiefarchitect.com/3d-library/?r=site/library&x=true&search=Posts and Columns

Thanks. I thought for sure I got it happen automagically before.

I know I've done this before, unless I am loosing my mind. How do I get the sub-floor to read as 911.5' rather than 0' ? I did a search but I am loosing it this morning!

@Renerabbitt

check your layer set attached to the plan view.

The problem, if I'm reading this right, is most likely that when you create your ceiling plane, you need to ensure that the settings for the CEILING plane are set at the room height. Once you turn off the flat ceiling, the ceiling plane you draw in now takes precedent. Check your ceiling base height.

You have a saved plan view connected to those foundation plan(s) and are re-using the SVP and layer set associated with it. Read a bit about SAVED PLAN VIEWS and you will see that, most likely you are not using them...at least not correctly...and thus you should probably just delete that saved plan view and then use different plan files for those foundation options.

It sounds like you are sending a specific plan view to the layout and even though you are changing the plan and resending, you are not switching the plan view, and thus, its updating whats there. Unlink the plan view(s) or simply delete them if you aren't really using them. Or...you want 3 different foundation options for the same floor plan, easy enough but you do need separate plan files for that. When I do these for spec builders I have the MASTER PLAN FILE_CRAWL SPACE, then save as and name it ..._BASEMENT, then ..._SLAB and send those separate plans to the one single layout.

I would make the girder truss a symbol so that you can position it accordingly without needed to create extra ceiling planes. Open a blank plan and create the girder, turn it into a symbol if you can and bring it into your plan.

Just delete them in layout.

You can use a reference set that references the as-built plan.

What company? Where are you located?

I use a match line....

Don't use a library door, just use the door tool.

1/4" for me. Will use the 1/8" for those pesky pre-cut studs (@genedavis ) on my elevations, but 1/4" everywhere else possible.

Check the setting of the sub-fascia. If it's larger than the fascia it will push the wall down accordingly.

Just start drawing. Connect them with a slab "room" so that you can more easily control some heights and floor drops. Other than that, just get started.

Sounds like you have changed the location of where you stored those, or you are using a different computer to finish up a project. You simply need to relink those and your good. This happens when I am working on a project in the office but come home and work on it with my laptop. Your post sounds like you are panicking a bit, but it's all still there, just needs re-linked.

There are both 3D & 2D symbols in the Simpson Catalog. https://www.chiefarchitect.com/3d-library/index.php?r=site/library&reset=true

Bumping this up for the new year. Shoot me an email and I will send you the info.