joey_martin

I'm up in Elwood, just sent you a private message.

https://www.usg.com/content/usgcom/en/design-studio/wall-assemblies.html

Thanks for the quick response. This is a big miss for @ChiefArchitect with regards to the room finish schedule.

I don't get asked for these often, but I need it today and on a time crunch. Looked at vids and did a search. How do I get the ROOM FINISH SCHEDULE number to show in the room? Why is this not right in front of me? Or is it?

Or hit 2 on your keyboard (shortcut for join roof planes) and it will show you the projection as well, hit ESC if you choose not to join them.

@vikiw_bend is local to you.

Turn off AUTO ATTIC WALLS and delete that little piece of wall.

Short answer is no. What you want completed can not be done automatically.

I have a few in my library but recently updated my template for X15 and added almost all of them into the wall def drop down menu.

I use the material region tool.

Did nothing but take a section cut and set the depth cue. I just need to label and dimension it to have a nice building section.

I like it a lot...

Use the BEARING LINE TOOL over that beam/bearing wall and Chief will split the span.

I had to do the same. Completely removed my user catalog, went back to X14 and cleaned it up a bit and exported it, re-loaded in X15 and I'm all good so far.

@Eric_S there is no "thumbnail", though preview allowed me to get a little farther. When I click to open the User Catalog folder to see all my folders it hangs up again.

I will need to try this as well, if I can get to that point...

Turn off the view window label.

https://hometalk.chiefarchitect.com/gallery/image/481-columns-and-pillars/ Columns and Pillars library also.. https://www.chiefarchitect.com/3d-library/?r=site/library&x=true&search=Posts and Columns

Thanks. I thought for sure I got it happen automagically before.

I know I've done this before, unless I am loosing my mind. How do I get the sub-floor to read as 911.5' rather than 0' ? I did a search but I am loosing it this morning!

@Renerabbitt

check your layer set attached to the plan view.

The problem, if I'm reading this right, is most likely that when you create your ceiling plane, you need to ensure that the settings for the CEILING plane are set at the room height. Once you turn off the flat ceiling, the ceiling plane you draw in now takes precedent. Check your ceiling base height.

You have a saved plan view connected to those foundation plan(s) and are re-using the SVP and layer set associated with it. Read a bit about SAVED PLAN VIEWS and you will see that, most likely you are not using them...at least not correctly...and thus you should probably just delete that saved plan view and then use different plan files for those foundation options.