DRAWZILLA

i have asked that this be fixed for many years, we need Chief to give us separate ridge and ledger edit boxes. Right now I just put the ridge in with the roof beam tool and leave the ridge the same size as the rafters. Edit. also need a way to have ,or not have, a fascia on any selected roof plane edge.

black flicker is still there for me.

everything went fine for me, no problems.

It's now called plumbing fixtures.

I also see this.

You can also try to turn on "rooms" for that view

I would also crank up the exposure to around 70 and add 20 to the saturation and brightness

300 for me but test out different resolutions to see if that helps.

I use a reference display ,also good for showing roofs on different levels

pony wall with a wall cap is the way I would attack it also

I have been using windows 11 on my desktop for a few months now and not seeing any problems with Chief so far. As for a laptop, I don't use one, screen is just too small for these tired eyes.

I will use a 24" door for a walk-in attic access door.

I would use a "PBR" and export it using a high resolution. This is of course if your video card can handle it.

I have been using a 3060 12gb for some time now and it' works just fine , I did pay too much for it 1300, at that time, but not seeing any problems so far

You can use reference sets to do that. You should check in each door's dbx to see if show concrete cutout is checked, then it will show on the foundation plan. Sorry I didn't download the plan.

Larry , I have been using windows 11 for about 6 months now, at first there were some problems but nothing I couldn't work around. they have fixed all that now and it's working fine.

THANKS Joe, those stair macros are working very good, they save me a lot of work.

pigs always fly around here I flew then and I will fly now when I have to seats are just too small for me , btw I flew there first class with lots of legroom

Larry ,I sometimes see this , not sure why but it does happen.

My engineer lets me use 3x4 full height studs at stairs

I use 2x4 framing with r-15 in the walls all the time but this is California where the energy code is tougher than the ICC codes, I also use the computer method where you can trade off different methods.

never use fit to page, use scale

also try to up the exposure setting

if you move the full height wall edge around a little it will fill in the drywall, but you have to get it just right

I'm always deleting that fill. takes extra time