Sign in to follow this  
sthieldesign

How do you create Atrium windows?

Recommended Posts

I am trying to recreate Atrium windows per plan.  Can anyone help me on how to do this?

post-2660-0-84991500-1461789994_thumb.jpg

post-2660-0-37661400-1461790005_thumb.jpg

post-2660-0-66035400-1461790014_thumb.jpg

Share this post


Link to post
Share on other sites

There are Atrium Window Symbols in the Core/Architectural/Windows Library Folder.  They can be placed as needed.  If you need to have them on a Solid Railing Wall you simply set the bottom elevation to the top height of the wall.

Share this post


Link to post
Share on other sites

I see you got it close already. If the Chief symbols will not work try posting your plan.

 

Dave

Share this post


Link to post
Share on other sites

You guys have me curious though how those act as the roof as well?  I'll play around with it....

Share this post


Link to post
Share on other sites

Or...have a look at the Garden window at Architectural...Windows... Window Units...Protruding...Garden.

It may be a little easier if it suits.

post-106-0-43484400-1461799298_thumb.jpg

Share this post


Link to post
Share on other sites

Thanks Glenn but windows sit on the exterior wall and angle into roof so that won't work for this job.

Share this post


Link to post
Share on other sites

I played around with it a bit. Added a pony wall where the windows would butt up to house because you would need a wall there. so pony wall has doorway full width of that alcove. If it is an as built, then you could drag the wall back towards kitchen and extend windows in those couple inches.

 

507 Dahlia Susan 042616 revised.plan

Share this post


Link to post
Share on other sites

Actually you already did it, its just the wall got moved so there was no floor, hence the grass.. Just connect the wall again.

 

Good Work

 

 

post-637-0-15047900-1461852774_thumb.jpg

Share this post


Link to post
Share on other sites

Thank you so much guys! I can proceed now, hate it when I spend hours trying to figure one little thing out  instead of the design itself.  Thanks so much:)

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
Sign in to follow this  

  • Member Statistics

    28863
    Total Members
    9156
    Most Online
    Stephanie_M
    Newest Member
    Stephanie_M
    Joined