ShaneK

Grab roof planes drag them to overhang you want, go to attic and move gable attic wall out to match roof you just moved. Chief will regenerate another wall but it works in seconds no settings to change.

TY

Can an entire layout be linked to a new file in quick way?

you can adjust it in the annotation set you are using. Change your defaults if you want it to stick forever.

All your walls on 3rd floor are attic and no room definition. Change all of that too.

All the blue walls were not needed and stopping you from adding a floating dormer. I deleted blue walls on 3rd floor and you had some walls in attic that stopped center dormer from generating. I believe you tried using the auto dormer tool that is where holes in roof came from. I did not draw any walls, deletes and auto floating dormer. Explode dormer and you can move stuff, but be careful. When I said "clean up dormers" I was referring to wrong colors or materials.

You need to clean up dormers. Orphanos Foundation Renovations shane.zip

#2

Now give Solver a point for helping you!!!!!

I have many walk-outs and all are on floor zero. Pay attention to deep footings and site elevations.

Slab detail.plan

I beat tech support by 1 hour with same advice.

I have no idea, it was easier to make new for you Arch D 36 x 24 portrait.layout

maybe red line is outside of the printer margins. Everything on page 0 should show up on all pages.

Quick fix is to make your bottom layer of osb "no material" or "air gap". Cross section will be accurate and 3d views are normal.

low battery or re-boot or 22 oz hammer.

Bullet proof was factored in when design was taking place then we received price on bullet proof glass and,,,,,,,,,,,,,,,,, you can shoot through the glass but not the wall.

I did not try and I'm sure I can't without workaround of some sort. Love the challenge and all you smart folks sharing info.

open risers

I did it in chief, converted to symbol, deleted center stringer.

I couldn't stand it,,,,,,,,,,,, I had to accept the challenge

David gets a point or 2 or 3 but do tell your method of madness.

I see no hinge options at all anywhere in cabinet dbx,,,,,,,, only option is off set from top or bottom. BUT I'm sure someone has a work around and will chime in soon.

Cabinet Gurus will be chiming in soon,,,,,,, until then where did it tell you 3 hinges were default?

Cost was off the CHARTS