Mark3D

There is something very strange there i can not see what is causing it

try copying the gable line to the front side

with that glitch un tick upper pitch on the skillion gable walls

Have a look at this file and see if it is what you want there is a little glitch in the corner where the skillion roof meets i would clean it up manually buy turning off auto roof after you have your roof right and manually adjust LenhartPlan09142021.plan

Reply to keep current

this is a old thread from 2014 i have the file and it is not doing it in x13 i deleted my last reply as i did not realize it was old thread

upload your plan some one might do it for you

This is a roof that you can get 95% there with auto roof tool by changing the bedroom area roof group to 1 then most off your problem are gone with off angles and just some minor manual roof work at the end

My guess is you have turned off one of your snaps and you are drawing of angle, you may have turned off by mistake and forgot

the edge of that roof plane is off angle check its selected line 1 roof plane is over 90 and the other is under 90

How i fixed i just selected the gable attic walls then just auto re built them and the side triangle walls i had to pullback the lower roof plains as chief stops walls below roof plains

See if that is getting better i think may have setup your exterior walls wrong unless i am missing some thing to me they should be a single wall unit Also that small image is a bit to small to see Barndominium.zip

No problems for me amd desktop and laptop both good

upload your file you will most likely get a fix

Help with getting terrains working or complete terrain model Minor fixes or a tip to get things working free Major fixes ask about fees private message me Complete terrain model ask about fees private message me

open this plan i have put some instructions in it to follow Sloping Block 2.plan

Here is chief file with cad in it to help with showing house position Sloping Block.plan

the hatched box is a copy of your terrain is that how you would place your house or if not can you explain

Are you using x7 or have forgot to update your signature in chief talk

Ceiling height needs match

Would that be close enough if so it is just using railing panel from core catalog and the hand rail can be set to what ever you want

try this file i put the roof at 25 pitch Huis_mei_2021.plan

Have look at this file see if it is on the right track Huis_mei_2021.plan

Have a look at this file it is working a lot better i added a terrain break set retaining walls to default top and bottom heights and tweeked the terrain data to help 24wc_left_7ft_exp2.plan

When i was looking at your file i noticed you had terrain data on top of terrain data there is a elevation region in front of garage if you keep the elevation region and remove the elevation lines in the same space as your elevation region buy doing a complete break and deleting the over lapping data your terrain will behave much better you should never have multiple elevation data in the same space