GaryOhmer

check your roof baselines The Majestic hip.zip The Majestic gable.zip

thanx

anybody have experience with Epson EcoTank Pro ET-16650 ?

I used 2" rigid insulation under 1 x 2 , along with a vertical piece with pitch cut , then foamed all the cracks - insulation is only good as the dead air that it occupies - drive around on a cold wintry day and see how many houses have ice cycles hanging - you won't find them on our house -

I'm not very good at this - after you define your shower - go to room defaults - structure - edit floor finish to what your sub base will be (thinset ,etc ) + thickness (like 1" thinset). Now you can use the polyslab set to the thickness of your tile 1/4", 3/8" or what ever - change the material to what your main tile is - set the bottom of the slab to what the thickness of your substrate (1") so the top of the slab will be 1 1/4" to the top if you use 1/4" tile - adjust to the perimeter minus your 3/4" - now do the same thing for the perimeter and use the penny tiles - draw 4 rectangles for the perimeter - confused?

Usually what's obvious is the first to overlook

You might not have the window in full - grab the top of the chief window and snap to the top , should restore full window

Everyone of those houses would already be in the mold and rot stage here in Ketchikan, Alaska - our record rainfall is over 16'

I'm using an old mx master and have no problems at all

thanks

I use the desktop version - does it work with x13?

I do mostly interior trim any more - so when I draw a hall with a 36" door at the end I make the hall 3'11 not 48" - 2 king studs and a cripple will give 5 1/2" per side x 2 + 36 = 3'11 so I frame all my closets etc over by 11" , 5 1/2 each side

I open the room - name it closet - the font size is 4, I want a size 3 - so after naming room I double click the name to change the font - I'd like to do that when I name the room.

I'd love to change the size of the room font right when I name the room.

You can always use a custom ceiling planes to do the job

make as many of the walls that that you want invisible

and now they're back

They're gone

Is chief redoing the cabinet catalogues?

2 opposing 4/12 roofs

I know that you can do the sides , but what about the top and bottom - matching two opposing roofs

Is it possible to create a isosceles trapezoid window?

THESE PLANS HAVE BEEN DRAWN FOR THE CUSTOMER AT THE CUSTOMER'S REQUEST. EXTRA ENGINEERING MAY BE REQUIRED FOR SPECIAL FOUNDATION DESIGNS DUE TO SLOPE & SOIL CONDITIONS AND A LATERAL ANALYSIS MAY BE REQUIRED FOR WIND AND EARTHQUAKE DESIGN. OHMER'S RENDERINGS MAKE NO WARRANTIES, EXPRESSED OR IMPLIED, REGARDING PLANS. CUSTOMER SHOULD HAVE PLANS REVIEWED BY A LICENSED BUILDER, ENGINEER OR ARCHITECT PRIOR TO CONSTRUCTION, SOME MODIFICATION MAY BE NECESSARY FOR COMPLIANCE WITH LOCAL AND STATE REGULATIONS. Is what I use on my plans

Search for pool table instead of billiard table in library

What about a large spiral?