Extra/double interior wall frame – how to define corner connection?

[meanwhile]

I'm working on a project where the contractor decided to frame an extra stud layer on the interior side of this kitchen (in order to create enough depth for plumbing and a washer/dryer hookup).

 

How do I adjust the way the walls connect at the corners so that the extra framing layer hugs the inside of the walls on each side, rather than cutting halfway through them?

 

 

[SHCanada2]

i have to do that every once in awhile and have not run into that issue. Do you have two walls there or one wall with 2 walls in the definition?

 

regardless, have you tried the wall intersection tool?

 

[mtldesigns]

18 hours ago, SHCanada2 said:

2 walls in the definition

Def. the way I've done this in the past.  See the attached for wall dbx

 

 

Edited 7 hours ago by mtldesigns

[meanwhile]

Just a single wall on my end with 2 layers of framing in the definition. Strange it's behaving differently over here.

 

I'm unfortunately using Home Designer and dang, looks like there is no wall intersection tool. I did try adjusting the Through Wall at Start/End intersection settings, but that causes it to go all the way through to the exterior of the house, which of course isn't right.

 

Oh well, I'll just let this one go. Thanks anyway all

 

Edited 7 hours ago by meanwhile

[SHCanada2]

i will normally put a second wall with no room definition, or break the wall and change the thickness