LAYERS NOT DISPLAYING CORRECTLY WHEN MODIFYING LAYER SET

[kwhitt]

I may have found another issue with the latest release of X15.

 

I am creating a cross section and want to display “Cabinets, Custom Backsplashes” only so that I can send off for a quote – see attached video.  As you can see the screen will not update with a change in the layer’s visibility.  On an individual basis there is no problem; however, when I select all layers to turn them all off and then select a couple that I want visible, nothing appears.  I've been using this technique for years with no problems.

Can anyone confirm this?

[GeneDavis]

Can't comment without the plan.  Post it.

[kwhitt]

  On 8/14/2023 at 12:28 PM, GeneDavis said:

Can't comment without the plan.  Post it.

Expand  

The plan is too large to post here.  I can upload to DB and provide a link.

[kwhitt]

  On 8/14/2023 at 12:28 PM, GeneDavis said:

Can't comment without the plan.  Post it.

Expand  

Here's the download link:

 

https://www.dropbox.com/scl/fo/8t8k1pusihbbw130kn9nt/h?rlkey=h0nuxj7mlfz5cg3p1664wlh11&dl=0

 

Thanks, Kevin

[kwhitt]

This is a basement level.  When I turn off the layers one by one I find that the layer "Foundation" turns everything off on this floor.  I guess this was the problem.

[DBCooper]

  Quote

I find that the layer "Foundation" turns everything off on this floor.

Expand  

 

Been bitten by that one myself.  The "rooms" layer is another one that will get you.

 

[ValleyGuy]

I've had the same issue a couple of times...."rooms" was the culprit that needed to be checked once and "CAD Default" was the other.

[kwhitt]

  On 8/15/2023 at 12:19 AM, ValleyGuy said:

I've had the same issue a couple of times...."rooms" was the culprit that needed to be checked once and "CAD Default" was the other.

Expand  

I didn't even realize you could turn off an entire floor.

[TeaTime]

  On 8/15/2023 at 11:31 AM, kwhitt said:

I didn't even realize you could turn off an entire floor.

Expand  

Only "Foundation", it's special.