GeneDavis Posted May 21 Share Posted May 21 When in CAD detail 2D mode, I am always getting unwated points. Happens in wall framing detail and truss detail views, plus any CAD detail I have created. Sometimes they are stacked on top of each other, as if copied and pasted in place, and deleting them takes multiple clicks or window select to delete. What could be the cause? I gotta solve this. Link to comment Share on other sites More sharing options...
kMoquin Posted May 21 Share Posted May 21 I've seen this behavior as well. Link to comment Share on other sites More sharing options...
GeneDavis Posted May 21 Author Share Posted May 21 Just spoke with tech support and it's a known issue and they "hope" it'll be gone by the time X18 comes around. What is particularly annoying is that deleting them isn't permanent. They come back right exactly where they were before. I was hoping for an update, say, tomorrow. Link to comment Share on other sites More sharing options...
mtldesigns Posted May 21 Share Posted May 21 3 hours ago, GeneDavis said: They come back right exactly where they were before. Yes they do. Glad they know about it. Link to comment Share on other sites More sharing options...
tundra_dweller Posted May 22 Share Posted May 22 Glad I'm not the only one who's run into this, I couldn't figure out what would be causing this. After seeing the op pic they even seem to be in the same pattern as I usually see, so I know this is probably a software issue vs user issue. Link to comment Share on other sites More sharing options...
glennw Posted May 22 Share Posted May 22 My guess is that they are Point Markers left over from deleted Point to Point dimensions.....or something similar. 1 1 Link to comment Share on other sites More sharing options...
AndrewSopher Posted Tuesday at 04:01 PM Share Posted Tuesday at 04:01 PM I am having this exact issue. Super frustrating. Happening in almost every detail. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now