Auto-Filling Wall Tops Under Exposed Rafter Tails?

[HumbleChief]

Is there a way to do so other than manually pulling up each wall in 3D?

[DRAWZILLA]

try setting your sub-fascia to "0"

 

[HumbleChief]

Thanks P, hope you're doing well! Tried a bunch of options but no love so far. Have t you ever had it work?

[Gawdzira]

I just had a conversation with myself about this

 

 

[DRAWZILLA]

By setting the sub-fascia to 0 it may cut off the beams from showing so you then have to manually place the overhang beams. I remember a time when it worked well but it may have been a long time ago. doing good Larry, just working, but not as much as I use to. slowed down a bit.

 

[Kbird1]

2 hours ago, HumbleChief said:

Thanks P, hope you're doing well! Tried a bunch of options but no love so far. Have t you ever had it work?

 

As Allan mentioned Larry for P's trick to work the Soffits must be ON.... 

 

Allan's settings

 

Posted July 19

 I think I got it. Soffits have to be active but cheating the eave sub fascia to tiny gets the look.

 

 

[HumbleChief]

THANK YOU SO MUCH!!! Struggled with that forever!!!

[DRAWZILLA]

thanks k-Bird for that important info. I guess I forgot that, but my soffits are always on.

[Kbird1]

1 hour ago, DRAWZILLA said:

thanks k-Bird for that important info. I guess I forgot that, but my soffits are always on.

 

Allan had already mentioned it so there was no need to re-write it , so this one goes to Him

 

M.