door and drawer face sizes

[DGail1]

Is there any way to specify drawer/door front dimensions in the cabinet specifications?

 

I'm using x14, which finally shows door and drawer front heights & widths, but doesn't allow you to set those.  I've adjusted item heights, separation heights, even used blank areas to "fudge" the results but I can't get all the fronts to the sizes my cabinet maker uses.  

 

30" cabinet box, frameless construction.

I need 5 15/16", 11 15/16, 11 15/16 with 1/8" reveal between fronts.  

I can get 2 out of 3 drawer fronts right, but nothing I've tried will allow me to get the 3rd one right.

 

Any suggestions?

[Joe_Carrick]

Try adjusting the toekick height and/or countertop height or thickness.  You need to have the cabinet itself (not including the toekick) exactly 1/2" more than the sum of the drawers.

 

[MarkMc]

48 minutes ago, DGail1 said:

30" cabinet box, frameless construction.

I need 5 15/16", 11 15/16, 11 15/16 with 1/8" reveal between fronts.  

That adds up to 30 1/16" is a part of the reason

 

Even than- to get those faces you have no reveal at the bottom (have had makers do that)

AND no reveal at the top which I've never seen and would never ever allow. Something is off??

[rgardner]

 

Pay attention to the box that says "Front Height:"

[Kbird1]

3 hours ago, DGail1 said:

30" cabinet box, frameless construction.

I need 5 15/16", 11 15/16, 11 15/16 with 1/8" reveal between fronts.  

I can get 2 out of 3 drawer fronts right, but nothing I've tried will allow me to get the 3rd one right.

 

 

Are you sure the box isn't actually 30 1/4"  sitting on a 4 1/2" Kick  to allow for 3cm ( 1 1/4") Quartz Counters?  for the standard 36" height ? 

 

 

 

[DGail1]

Definitely 30" box, 4 1/2" toe kick, 1 1/4 counter = 35 3/4" total height.  Sorry Joe, those can't be changed

However, thanks Markmc for pointing out my math error...that's what happens when I pull all-nighters.  I double checked with my cabinet maker...7/8 instead of 15/16...and it works!

I think I've got it licked now, thanks to everyone for your help!  Sometimes it just takes another perspective to be able to see more clearly.

[Joe_Carrick]

49 minutes ago, DGail1 said:

Sorry Joe, those can't be changed

That's what you get with stock cabinets.  I use a company that is much more flexible in their sizes.  

OTOH, I never have to specify the door or drawer sizes.  The Cabinet Manufacturer does it automatically even when I specify odd sizes down to 1/16" increments.