Mark3D
-
Posts
718 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Everything posted by Mark3D
-
Export the PDFs to image open in image editor adjust contrast then bring in to chief
-
Because of default reset at a guess as i am not infront of chief at this time
-
You must have change your ceiling finish material as the there zero for your finish layers and material check it out
-
I dont no what you did to make it that way but if you Reset defaults it fixes it Steps Edit menu Reset defaults i checked all settings
-
New Chief Architect 3D Viewer - for Mobile Devices
Mark3D replied to scottharris's topic in General Q & A
There skecthfab that can do similar but it has a serious weekness it can't do rotating plant images so please put that ability in this app and I will be very happy -
Internet security software was causing me to have slow startup times i changed from bit defender to vipre and that fixed my problems
-
Dropbox sounds good
-
I can do that
-
I would say the same it has learning curb but there forum I would even say they are even more helpful than this forumAlso it seems to be dead as far as future development
-
Not sure about incorrect bit but to me I would be using a mouldings line
-
Can somebody tell me why my plate and studs are too low
Mark3D replied to cjanderson66's topic in General Q & A
You have pulled the bottom of the wall down i think to bring the stone down to the terrain best to check wall bottom default height and use slabs or other to extend your stone -
Dont no if this will cause other problem but i selected same height eaves and that got it working
-
Also VRML and colada I think exports by material but you loose object names
-
That job only
-
Use the rainbow tool on camera view go to texture tab rotate 90 degree
-
If I understand you draw your wall clockwise also you can flip the layer at any time if needed
-
With the small gable pull your roof plans paste the wall cladding buy the thickness of your Fascia and with the big gable hole turn on reference layers extend the gable wall to the point where it will hit the 2 roof plans https://dl.dropboxusercontent.com/u/29819538/Untitled%201.plan
-
i thought i read that david potter had it working on windows 10 try a search of this forum
-
Have a look at this i removed a lot of elavation data and it seem better but i may have removed to much but it will give you the idea https://dl.dropboxusercontent.com/u/29819538/Costa%20Rica%20Test.plan
-
Retaining Walls Not Working With Imported Elevation Data?
Mark3D replied to tandrasz's topic in General Q & A
You need to adjust your terrain elevation data like it needs to be different on each side of the retaining wall so break your elevation lines on the lower level area and adjust the heights as needed https://dl.dropboxusercontent.com/u/29819538/Terrain_good2.plan -
I was just giving it a go I am no expert with stairs but I did try to open your file to see what you came up with but you must not have closed chief when you zip as no data error
-
This my go at it https://dl.dropboxusercontent.com/u/29819538/CatalinaMark%20try.plan
-
Exporting Floor Plan as Picture in High Quality
Mark3D replied to Rosco2017's topic in General Q & A
I would print to PDF then from PDF editor export as image that should give a nice sharp image -
Can give a screen shot image as it helps to understand your situation
-
You need to watch the announcements section they are betta testing it
