Ceiling soffits only appearing above cabinets

[alwaysdesigning]

hi, i inserted a ceiling soffit (which has plumbing and ducts ect in it) and it will only appear above cabinets in 3d.. .. how do I make it appear everywhere that I have placed it.. ?

 

thanks

[Joe_Carrick]

You need to check the height.  It may be sitting on the floor.

[alwaysdesigning]

no the height is correct but it only appears above the cabinets in the 3D.. but in my 2D view, I ran the soffit into the hallway and bathroom (because it has ducts in it) but it will not appear in those other areas.

[DRAWZILLA]

Is that layer turned on in that view

[Joe_Carrick]

Post the Plan - please!

[mydog8it]

I've found that portions of soffits disappear in 3D if you run them over/through a wall (ie: from a kitchen into a hallway, it will only show in one room or the other). I make two separate soffits, one on each side of the wall, and then they display fine for me.

[alwaysdesigning]

@mydog8it.. YES! that was the problem.. i ran the soffit continously through a wall and that was why that was happening.. creating a separate soffit on each side of wall, as you mentioend fixed it.

 

thanks.

[tommy1]

I've found that portions of soffits disappear in 3D if you run them over/through a wall (ie: from a kitchen into a hallway, it will only show in one room or the other). I make two separate soffits, one on each side of the wall, and then they display fine for me.

 

Soffits have always acted like this. Never run them through a wall.