Unwanted points in detail window mode

[GeneDavis]

When in CAD detail 2D mode, I am always getting unwated points.  Happens in wall framing detail and truss detail views, plus any CAD detail I have created.

 

Sometimes they are stacked on top of each other, as if copied and pasted in place, and deleting them takes multiple clicks or window select to delete.

 

What could be the cause?  I gotta solve this.

 

 

 

[kMoquin]

I've seen this behavior as well.

[GeneDavis]

Just spoke with tech support and it's a known issue and they "hope" it'll be gone by the time X18 comes around.  What is particularly annoying is that deleting them isn't permanent.  They come back right exactly where they were before.

 

I was hoping for an update, say, tomorrow. 

[mtldesigns]

 

3 hours ago, GeneDavis said:

They come back right exactly where they were before.

Yes they do.  Glad they know about it.

[tundra_dweller]

Glad I'm not the only one who's run into this, I couldn't figure out what would be causing this. After seeing the op pic they even seem to be in the same pattern as I usually see, so I know this is probably a software issue vs user issue.

[glennw]

My guess is that they are Point Markers left over from deleted Point to Point dimensions.....or something similar.