mrsmith Posted December 7, 2018 Share Posted December 7, 2018 Trying to raise a floor beam flush with the top of the joists, and no matter which measurement I try to change, I get an error message. Any suggestions? Using X10 on a Mac. Link to comment Share on other sites More sharing options...
Joe_Carrick Posted December 7, 2018 Share Posted December 7, 2018 Try not including the " Link to comment Share on other sites More sharing options...
Kbird1 Posted December 7, 2018 Share Posted December 7, 2018 perhaps if you entered a positive number it is refusing to do it ? since the other numbers are negative but Eric is right best to post the plan for quick answers like this. M. Link to comment Share on other sites More sharing options...
glennw Posted December 7, 2018 Share Posted December 7, 2018 I have had this happen as part of an ongoing problem i am having with Chief. What do you see if you go Preferences>General>Unit Conversions after seeing this message? Do you get the same error message when entering a distance into any dbx? What happens when you draw a dimension and/or what happens to existing dimensions? I suggest that you keep the Chief session open to help with trouble shooting. But, does closing the existing plan and opening a new plan result in the same behavior? Does the problem resolve with a new chief session? Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now