wall section arrows

[mtldesigns]

Doing a Kitchen & Bath set, 1/2" scale.  In this set I have a Wall Elevation camera that is showig up on all other sets of that same view (Floor plan, framing plan, etc...)  How do I turn this off where it shows only on the set I want?  I created a new layer and put this camera on, to no avail. 

[Chopsaw]

Is that camera open by any chance?

[Alaskan_Son]

Chopsaw probably nailed it. Cameras will always display if the particular camera view is open. Don't worry though, they only display while they're open and won't print that way.

[DRAWZILLA]

And there is a setting in the camera DBX where you can show on all floors or not.

[mtldesigns]

I figured it out.. its a setting "display as callout".  This doesn't show any camera, and instead I can put my own "callout" in on that specific set.

 

Thanks to all.