• Posts

  • Joined

  • Last visited

Everything posted by Francois

  1. Chopsaw, this is what I get when I select a room.
  2. Take two!
  3. I downloaded 7-Zip and was surprised it was only 2kb size. I'll do it again. Thanks for checking it.
  4. Manisha01-Plan-Side_Entry00-Ca-Copy.plan Here is the zip
  5. Even when selecting exterior room, the whole building is selected. At your suggestion I checked for something above the building with no results. I'll post the plan.
  6. I have not yet applied Perry and Copsaw's suggestion. I will give it a try though in a few mn
  7. I used to select one single room and that room would be highlighted. Now with the same selection the whole building is highlighted. Then I can select that room with one Tab click. Extra step but unusal.
  8. Suddenly selecting one room highlights the whole floor plan including the foundation. Pressing Tab will select the chosen room. I never had that before. How do I get back to "normal"?
  9. The reduction factor will affect the design on the layout but not the size of the page which can be change in Paper Source in the Print dialog.
  10. I'm about to upgrade my computer. Will X13 require a hardware upgrade for max performance?
  11. I have been called for that type of endings in bay area California for disconnect in hand rail !!!
  12. I was told by a tech lady from CA that there is a recommendation for graphics card on their website regarding ray tracing. You might check it out.
  13. I have imported a 3D DXF file from a Disto lase tape I can read all data points in 2D only and placed the walls but how do I get the vertical plane so I control the heiht of room, window andoors? I do not have Autocad I have attached the plan along with the 2D and 3D files that the Disto produced. Thanks 2DG_20200908_071825.dxf 2DW_20200908_071825.dxf 3D_20200908_071825.dxf Disto CA Test 01.plan
  14. Have you checked ""? they have it on sale. I'll buy a (different) unit from them for they return policy and their support
  15. Page 0 is where you create and edit anything that will be permanent on all pages. It works for any page size you choose.
  16. Thanks Bob. I was trying it from plan instead of layout. All good now.
  17. My layout contains plan files from different folders. How do I find the address of a plan file in the computer?
  18. It's only CAD lines and text. That's how I do it.
  19. Cat6e will be the game changer but not before the end of the year. Much greater speed. Not working at full speed on Cat6 cable.
  20. you can design it that way but I think it might create problems building the stairs ( post anchor location and 6" requirement from tread...). There is a video on YouTube that explained it. I'll look for it.
  21. It happen to me before. Here is a link to my rescue
  22. I have HP Spectre360 with Intel 620 chip. It runs two external monitors; one 24in 1080 and one 27in 4k with no problem.
  23. Thanks Rene. I have loaded the file Cab Extruded Handle Piano.plan Cab Extruded Handle Piano.plan
  24. I was working on a CAD detail in metric and that happened. How did I get these dimension lines and how to get rid of them? I tried and played with Preferences and Defaults for no results. Cab Extruded Handle