Bench1705mark Posted October 31 Share Posted October 31 I have created elevation lines at 1' increments and I keep getting this mound which I can't control. I have deleted the elevation lines several times and this mound appears every time. Any help would be greatly appreciated. John Link to comment Share on other sites More sharing options...
javatom Posted October 31 Share Posted October 31 Without seeing the plan it can be hard to tell. You might try opening the terrain dialog box and set the surface smoothing and triangle count to LOW. Link to comment Share on other sites More sharing options...
robdyck Posted October 31 Share Posted October 31 If you can post your plan file, some generous person will point out the exact problem and solution almost immediately! Link to comment Share on other sites More sharing options...
Bench1705mark Posted November 1 Author Share Posted November 1 attached is the compressed zip file. John E-C 11-12 ZIP.zip Link to comment Share on other sites More sharing options...
basketballman Posted November 1 Share Posted November 1 I use elevation regions instead of lines or points and don't have any of those problems Link to comment Share on other sites More sharing options...
Mark3D Posted November 2 Share Posted November 2 On 11/2/2024 at 1:15 AM, Bench1705mark said: attached is the compressed zip file. John E-C 11-12 ZIP.zip 216 B · 1 download when zip the file it needs to not open in chief as you get a file with no data in it try uploading with it not open in chief Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now