Hammer7 Posted April 27, 2020 Share Posted April 27, 2020 When I take an elevation camera view I have framing sticking up through the roof but it is not there in the orthographic view....? What would cause something like this where the plan is representing something different depending on view? GUERINNI-PLAN_April_8.2020.plan Link to comment Share on other sites More sharing options...
DavidJPotter Posted April 27, 2020 Share Posted April 27, 2020 Obviously you built framing and then changed your mind and edited the roof without building framing a new after you changed the roof. Just order framing to be built again and then all will be well. The software only does what you tell it to do when you tell it. DJP 1 Link to comment Share on other sites More sharing options...
robdyck Posted April 27, 2020 Share Posted April 27, 2020 And the reason is shows in some views as opposed to others is controlled by layer settings for each view (Display Options). For elevation views, you might want to setup a layer set that does not show framing. Then save and name those views. 1 Link to comment Share on other sites More sharing options...
tommy1 Posted April 27, 2020 Share Posted April 27, 2020 As David commented, once you've built framing and then you make structural changes, you then have to rebuild framing again. 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now