Mulling door and windows BUG?


Larry_Sweeney
 Share

Recommended Posts

I want to mull a casement window with sills on each side of a door. (attachment 1) Once I mull the units I have casing replacing the window and door sills and I lose the door sill. (attachment 2) I then opened the mulled unit and rechecked exterior sills, which is a custom sill profile and lose all casing & sills around the mulled unit. As shown in the third attachment, there is a "blank area" around the mulled unit where the casing a sills should be. Is this a bug or am I doing something wrong in my mulling setup? I've tried doing a search on the subject, but I'm either not "labeling" the search correctly or it has never been discussed before.

post-76-0-71527000-1435255792_thumb.jpg

post-76-0-41022000-1435256245_thumb.jpg

post-76-0-45727700-1435256261_thumb.jpg

Link to comment
Share on other sites

NOTE.............The second and third attachments should be reversed.

 

Joe..... "you might need to select/tab to each of the components and set the "Sill" there." Are you meaning by this statement that I should do this before I mull them? If that is the case then that was what I did. This shows in the first attachment before mulling the units.

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share