dimension not showing for dimension which needs leader line

[SHCanada2]

I've seen this before, but do not remember how to get it to show. it shows in the preview but not in the plan

 

Has anyone else seen this, and know how to rectify it ...without drawing a new dimension line

thanks

[MPDesign]

Maybe its your display wall width is turned off

[Doug_N]

Try pulling the dimension set outside of the others,  Maybe none of them have dimension extensions.  I see the actual dimension has been moved.  I suspect that dimension set does not have the same default set as others.  

 

[SHCanada2]

1 hour ago, Doug_N said:

Try pulling the dimension set outside of the others,  Maybe none of them have dimension extensions.  I see the actual dimension has been moved.  I suspect that dimension set does not have the same default set as others.  

hmmm, didn't seem work, but yes they are different one was inside dimensions pulled outside. I dont remember where the other one came from

 

6 hours ago, MPDesign said:

Maybe its your display wall width is turned off

what is that?

 

also on this plan is a missing end line for dimensions:

 

but its there in spirit when I click on it

 

...found the problem(the dimension showed 3 segments when there should have only been 2) with this one. it is catching the bulkhead or drywall which is 1/2" difference. If i remove the tiny 1/2" segment, it shows.

 

Original problem remains

[SHCanada2]

attached from the OOTB template with wall changed to furred

 

dimesion issue.plan

[SHCanada2]

"display wall widths" in the dimensions DBX makes it work

 

Uncheck Display Wall Widths to suppress those portions of the dimension line that measure between two surfaces of the same wall. Both sides of a wall may still be located, but its width will not display. This option is checked by default for most manually drawn dimensions, but is unchecked for Interior Dimensions

 

merci