Did You Know That A Measurement Of 1/64" In A DBX Will Not Show But Will Take Effect?

[HumbleChief]

Just learned that from tech support and could be a game changer in a few cases.

[DBCooper]

It depends on the dialog box.  Some controls will round to the nearest 1/16" no matter what you type in.

 

Also, you can change the "number style" to decimal inches to see what the real number is.

 

 

[HumbleChief]

6 minutes ago, DBCooper said:

It depends on the dialog box.  Some controls will round to the nearest 1/16" no matter what you type in.

 

Also, you can change the "number style" to decimal inches to see what the real number is.

 

 

Thanks, so I guess you did know that  I had that happen, rounding to the nearest 1/16 as shown in the dbx, but the value was 1/32 or 1/64. I'll keep that in mind because I know it will come up.

[DBCooper]

Chief Dermot shed some light on this here:

 

 

 

[Kbird1]

Chief will accept inputs down to 1/128th" but not all input boxes will show that so it looks like nothing has happened.

 

*I am not 100% sure ALL DBX's/Dims etc will accept 128th of an inch though.

 

M.