LOST FASCIA - Roof joining problems

[bdammeyer]

partial file.plan

 

Hello, 

 

x14 roof issue. I am joining a 9/12 gable roof to a 6:12 hipped roof. 

 

Both roofs are square cut and both fascia top heights and shadow board top heights are set to 119 5/8". 

 

Can anyone help me figure out why the fascia and shadow boards just disappear as shown here:  

 

 

partial file.plan

 

Thank You!

 

X14 - windows 11 - NVidia Geforce RTX3080

[SNestor]

Fixed plan attached; Partial Plan File Fixed.plan

 

The 9/12 gable roof was not centered...also, one side was 9/12, the other was an odd pitch (see screen clip). There are also extra break nodes in the valley that prevent joining of the valleys. 

[bdammeyer]

I did notice the roof was slightly off center after posting.  I have fixed that and removed the extra node. 

 

Still getting the same problem though. 

 

Were you able to get it to work on your end? 

 

 

[SNestor]

@bdammeyer - I posted a fixed plan above. 

[Chrisb222]

31 minutes ago, bdammeyer said:

I did notice the roof was slightly off center after posting.  I have fixed that and removed the extra node. 

 

Still getting the same problem though. 

 

It's not only that the roof is off-center. Fix the pitch and make sure the fascia top height settings stay the same. Then re-join the roof plane intersections:

 

 

However since you have two different pitches, with square cut eaves, the soffit height will be different as shown at the red circle.

 

The shadow board isn't showing on the eave because you have it set for gable only.

 

 

 

 

[bdammeyer]

thanks