Run Roof Rafter/Joists Parallel to Baseline?

[HumbleChief]

Can't remember how to do it? I've got an as built shallow sloped roof with the exterior walls raked to accommodate the slope with the rafter/joists running parallel to the baseline. Chief wants to run the rafters perpendicular to the baseline by default and I know there's way but can't remember how. THANKS

RAFTER 1.plan

[GeneDavis]

You can frame it manually but the rafters are going to be plumb, which may not be what you want.  I find no way to rotate them to have sections perpendicular to the roof plane.

[HumbleChief]

5 minutes ago, GeneDavis said:

You can frame it manually but the rafters are going to be plumb, which may not be what you want.  I find no way to rotate them to have sections perpendicular to the roof plane.

Thanks Gene, the slope is very shallow, probably 1/4" - 1/2":12 so plumb rafters are not a problem and I could have sworn there was a way to do this?  Thanks Again.

[TeaTime]

This is actually a great use of using Baseline Angle.

In the Roof spec, checking Pitch in Degrees shows the pitch you'd need to use - rotate your roof plane 90 degrees, set it 0 pitch and plug that baseline angle in.

[HumbleChief]

Yup Tea Time!! Got it Thanks so much.

[HumbleChief]

...and Eric (Solver), in a personal message, was kind enough to point me back to a previous thread I started with the same question. DOH!!