Getting "This is not a valid measurement" message when using a decimal?

[Bluneinc]

My employee is getting this message every time they use a decimal in their measurement.. I've tried changing the windows keyboard language to see if that was the problem but nope. She's added " or ' to the end of it and she still gets this message. What's the issue?

[Gawdzira]

It works for me. I just made a new line and adjusted the length.  X13. What is the rest of the workflow. Post a plan file where it does not work.

 

 

 

[Kbird1]

4 hours ago, Bluneinc said:

My employee is getting this message every time they use a decimal in their measurement.. I've tried changing the windows keyboard language to see if that was the problem but nope. She's added " or ' to the end of it and she still gets this message. What's the issue?

 

Sometimes the Error message does not show what was actually entered as Chief will try and auto-correct it , and sometimes it works and the Error message still shows.

 

It should work with " or '  but if neither is enter Chief assumes Inches in all cases, perhaps check KB in Notepad  to see if  a dot is a dot

 

M.

[Joe_Carrick]

Is it possible that she has the decimal separator set to be the comma?