joey_martin Posted August 8, 2021 Share Posted August 8, 2021 I have confirmed in X12 that this works properly, but in X13 not so much. I need to lower the ceiling of the porch.... But when I do, it's now dragging the entire floor down with it. Auto Roofs is now turned off, and I can't lower the porch ceiling without changing the entire floor....this is a BIG problem. Anyone else hitting this problem in X13? Link to comment Share on other sites More sharing options...
Chopsaw Posted August 8, 2021 Share Posted August 8, 2021 I just drew a very simplified version of what you have and it worked to lower the ceiling by dropping the Absolute Ceiling Elevation of the room. No apparent issues. Could you pull back from that inside corner and see if that is the issue ? Link to comment Share on other sites More sharing options...
joey_martin Posted August 8, 2021 Author Share Posted August 8, 2021 I was able to narrow it down to the cantilevered area. Once I pulled it back from there it worked as I wanted. I sent a bug report in along with the plan. 1 Link to comment Share on other sites More sharing options...
Alaskan_Son Posted August 9, 2021 Share Posted August 9, 2021 On 8/8/2021 at 8:56 AM, joey_martin said: I was able to narrow it down to the cantilevered area. Once I pulled it back from there it worked as I wanted. I sent a bug report in along with the plan. Not sure what you mean by "cantilevered area" since I haven't seen the plan, but.... It was also the case in X12 that whenever a room extended underneath a cantilevered portion of the room above, adjusting the ceiling height of the lower room would also adjust the floor above. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now