momsdesign 0 Posted January 15 I haven't researched this to thoroughly, but was wondering if it's possible to show pocket doors open and pushed back in 3d? Thank you! Share this post Link to post Share on other sites
tommy1 112 Posted January 15 I've done it but did it all manually. 1 Share this post Link to post Share on other sites
steve_stuart 12 Posted January 15 Someone was just asking about this the other day, check out this thread 1 Share this post Link to post Share on other sites
ericepv 18 Posted January 15 This is simple to do. Just open the DBX for the door and in the 'General' tab, adjust the swing angle (works for pocket doors too), then go to the 'Options' tab and click "Show Open' in the 3D Display section. Share this post Link to post Share on other sites
solver 1636 Posted January 15 4 minutes ago, ericepv said: This is simple to do. Just open the DBX for the door and in the 'General' tab, adjust the swing angle (works for pocket doors too), then go to the 'Options' tab and click "Show Open' in the 3D Display section. The question was about cabinet doors. Share this post Link to post Share on other sites
ericepv 18 Posted January 15 8 minutes ago, solver said: The question was about cabinet doors. The OP asked "if it's possible to show pocket doors open and pushed back in 3d?" Share this post Link to post Share on other sites
solver 1636 Posted January 15 44 minutes ago, ericepv said: The OP asked "if it's possible to show pocket doors open and pushed back in 3d?" Check the title of the thread. Show cabinet doors as pocket doors Share this post Link to post Share on other sites