DrewFenton Posted October 19, 2020 Share Posted October 19, 2020 I have searched the forums but only see very dated posts on this topic. Is there an easy way to make crown molding follow the angle / slope of a non-flat ceiling? I have attached a picture and placed red arrows where the crown would be applied. Link to comment Share on other sites More sharing options...
DzinEye Posted October 19, 2020 Share Posted October 19, 2020 You'll need to use molding polylines Link to comment Share on other sites More sharing options...
glennw Posted October 19, 2020 Share Posted October 19, 2020 You will need a 3D Molding Polyine. My prediction is that you will have trouble with the joints where a horizontal molding meets the sloping molding. They are not simple 45deg mitres. Link to comment Share on other sites More sharing options...
Kbird1 Posted October 20, 2020 Share Posted October 20, 2020 It doesn't work well in Chief as it doesn't work well in the real world either. M. Link to comment Share on other sites More sharing options...
DrewFenton Posted October 20, 2020 Author Share Posted October 20, 2020 Agree with you guys on the "real world" comments! Mine is not as challenging as typical crown because it is just a simple/rectangle 1x2. I will investigate the 3D molding polylines. Thank you all. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now