Framing Question Trusses & Rafters

[ACADuser]

I have a plan with trusses & want to build Deadwood at top of truss & ledgers at the bottom of the truss. See attached

I can not use "Hang Floor Platform" on the wall at this time.

So do I need to add the framing member that attaches to the CMU wall by hand or is there a way to auto-generate?

Below is what is generated when I use "Build Roof Framing". I suppose I could drag the rafters down to the ledger position.

BTW I can not post the plan at this time.

 

Thanks

 

[GeneDavis]

Edit your truss envelope so as to get the ledger notch.  Frame the ledger by hand, and same for the blocking.

 

Chief does a lot for us using the spec dialogs, but for this, you gotta do a little yourself.

[ACADuser]

Thanks Gene,

I've been doing it manually bit figured someone may have figured out a way to do more with the roof framing tool.

[Kbird1]

I think that is actually Chief's "Ridge" , so you could perhaps not build it ( 0"x 0")  and just place a Ceiling Beam manually, the rest is as you've been doing / Gene mentioned I think.