Room Specification (Structure)

[buzzsaw204]

hi 

 

 I want to change the ceiling height of the floor plan  from 9' to 10'

 

If the floorplan have multiple rooms drawn already,  I would have to go into each individual room to change  the ceiling height individually.

 

OR 

 

 erase all my walls,  change my ceiling height to 10',  then re draw all the rooms walls again

 

 Is there way to change the Room Specification all at once rather than selecting & changing each room at the time.

 

 

[DRAWZILLA]

Yes, floor defaults. If you already have a roof, you can delete it or raise the one you already have.

[buzzsaw204]

Yes, floor defaults. If you already have a roof, you can delete it or raise the one you already have.

 

the Floor Default setting will set 10' ceiling that is drawing for this point forward.

 

but is there a way to change what already drawn?

 

instead of.......erasing/delete all wall, change Floor Default, and redraw walls again.

[DRAWZILLA]

Floor defaults will change existing floors and ceilings.

[DRAWZILLA]

You can also use the "load same" and "select same " tools to do that.

[jscussel]

Do as Perry says. Change it in the Floor Defaults.

 

Jon

[lbuttery]

Changing floor defaults assumes that all rooms are the same

 

if they are different, then "select same - load same" is a better choice

 

Lew

[lbuttery]

if the roof has already been built

I found it handy to use the transform/replicate tool to move the roof planes 5' up

adjust the rooms then drop the roof 4' after verifying all the rooms were as desired

 

if lowering the ceiling heights raise 5' and then drop 6'

 

Lew