buzzsaw204 Posted September 6, 2014 Share Posted September 6, 2014 hi I want to change the ceiling height of the floor plan from 9' to 10' If the floorplan have multiple rooms drawn already, I would have to go into each individual room to change the ceiling height individually. OR erase all my walls, change my ceiling height to 10', then re draw all the rooms walls again Is there way to change the Room Specification all at once rather than selecting & changing each room at the time. Link to comment Share on other sites More sharing options...
DRAWZILLA Posted September 6, 2014 Share Posted September 6, 2014 Yes, floor defaults. If you already have a roof, you can delete it or raise the one you already have. Link to comment Share on other sites More sharing options...
buzzsaw204 Posted September 6, 2014 Author Share Posted September 6, 2014 Yes, floor defaults. If you already have a roof, you can delete it or raise the one you already have. the Floor Default setting will set 10' ceiling that is drawing for this point forward. but is there a way to change what already drawn? instead of.......erasing/delete all wall, change Floor Default, and redraw walls again. Link to comment Share on other sites More sharing options...
Solution DRAWZILLA Posted September 6, 2014 Solution Share Posted September 6, 2014 Floor defaults will change existing floors and ceilings. Link to comment Share on other sites More sharing options...
DRAWZILLA Posted September 6, 2014 Share Posted September 6, 2014 You can also use the "load same" and "select same " tools to do that. Link to comment Share on other sites More sharing options...
jscussel Posted September 6, 2014 Share Posted September 6, 2014 Do as Perry says. Change it in the Floor Defaults. Jon Link to comment Share on other sites More sharing options...
lbuttery Posted September 6, 2014 Share Posted September 6, 2014 Changing floor defaults assumes that all rooms are the same if they are different, then "select same - load same" is a better choice Lew Link to comment Share on other sites More sharing options...
lbuttery Posted September 6, 2014 Share Posted September 6, 2014 if the roof has already been built I found it handy to use the transform/replicate tool to move the roof planes 5' up adjust the rooms then drop the roof 4' after verifying all the rooms were as desired if lowering the ceiling heights raise 5' and then drop 6' Lew 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now