Roof Over-Frame Connect Issue

[RiverstoneMT]

Hello,

 

I'm using X16, and I keep running into a gable over frame issue. See Attached picture. 

Every time i create a new section of building with a different ceiling height, the auto roof creates two different planes, instead of just connecting the roof into the existing plane. I understand that the ridge may be higher in some situations, but in the past, the program just created a "broken hip" at the ridge. This has been happening since i switched to x16. Even when the new ridge is lower, it still creates what is shown in the picture.

 

I've attached the plan file too. 

 

I'm sure its something simple, but for some reason i cant seem to figure it out. Damuth Plan.plan

 

Specifically on this project, the blue section is going to be an addition to the existing home.

 

Thanks in advance