Ange822 Posted Tuesday at 06:07 PM Share Posted Tuesday at 06:07 PM Hi there - I'm wondering if there is a way to have the top fascia piece cut horizontally so it doesn't extend past the bottom fascia. I have played around with the different depth / options but think I am missing something. Thanks in advanced! Link to comment Share on other sites More sharing options...
ericepv Posted Tuesday at 08:31 PM Share Posted Tuesday at 08:31 PM Open the DBX for the roof panel and go to the 'Options' tab. There you can specify either Square or Plumb Eaves. Link to comment Share on other sites More sharing options...
Solution robdyck Posted Tuesday at 08:38 PM Solution Share Posted Tuesday at 08:38 PM Hi Ange, you could try copying that shadow board and set it to 1/16" thickness, Eaves Only, set it to an invisible material. Link to comment Share on other sites More sharing options...
Ange822 Posted Thursday at 12:12 PM Author Share Posted Thursday at 12:12 PM On 3/11/2025 at 4:31 PM, ericepv said: Open the DBX for the roof panel and go to the 'Options' tab. There you can specify either Square or Plumb Eaves. Thank you for the recommendation, I already have "plumb" checked off in the "options" tab. Link to comment Share on other sites More sharing options...
Ange822 Posted Thursday at 12:19 PM Author Share Posted Thursday at 12:19 PM On 3/11/2025 at 4:38 PM, robdyck said: Hi Ange, you could try copying that shadow board and set it to 1/16" thickness, Eaves Only, set it to an invisible material. Thanks Rob, this worked out perfectly! I just made a material that was 100% translucent! 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now