the window with the stucco look

[SHCanada2]

any ideas why this might happen

 

 

 

 

if i pull down the wall:

 

[SHCanada2]

hmm, i think i pulled the wall up earlier when I had the gable roof  lower ... but the default wall heights are greyed out so it must be autogenerated??

 

if I redraw the 2nd floor wall, then there CA creates the upper and lower wall, but then the lower wall shows as not the default wall height, and then if I check it, it goes back to being a two story wall

 

any idea how to fix it?

694 Muirfield Cr - fe.zip

[Garybills]

Hey Jason, I marked your porch as no Ceiling, and it fixed your problem. Then you will have to draw in a ceiling plane for the porch. I'm not sure why it's doing that!!!!!!

 

[Chrisb222]

6 hours ago, SHCanada2 said:

any ideas why this might happen

 

Instead of making the lower porch two stories, return its heights to default and draw another railing room on the second floor, make the railing walls invisible and mark the room open below.

 

[Chrisb222]

7 hours ago, SHCanada2 said:

any ideas why this might happen

 

Just to explain what's going on:

 

You placed the window on the second floor plan, but since you made the porch two stories, that wall is being driven by the first floor plan. The two-story first floor wall doesn't know the window is there. Alternatively to the above correct solution, you could place the window on the first floor then edit its vertical placement to get it where it belongs, but it won't show on the second floor plan.

 

 

[SHCanada2]

yes makes sense now that you have explained it  . Thank you

 

it was an inateresting look, the faux stucco window