brookesdesign 1 Posted April 6 I'm trying to recess my stairs into my front covered porch but I'm getting a small strip of subfloor under the wall where my steps start. I used a wall with an arched doorway to create the arched entrance where my stairs start. To create the area for the stairs I drew a room divide and called the space for the stairs as open to below. Is there a setting I'm missing to help clean this up? Share this post Link to post Share on other sites
solver 1682 Posted April 6 10 minutes ago, brookesdesign said: Is there a setting I'm missing to help clean this up? Probably. Open the doorway and see what you might not need. Share this post Link to post Share on other sites
brookesdesign 1 Posted April 6 I couldn't find any settings that cleaned it up but I tried dragging the bottom of the doorway below the stoop and that fixed it. I have to turn the casing off but at least the subfloor is gone. Share this post Link to post Share on other sites
brookesdesign 1 Posted April 7 My sill is turned off. It only goes away if I turn the casing off. Share this post Link to post Share on other sites
ericepv 19 Posted April 7 Try selecting the area in question and then check in 'Active Layer Display Options' to see what layer it's in. It would also be helpful if you post your plan. 1 Share this post Link to post Share on other sites
SPSEngineering 0 Posted April 7 Try changing the Riser Surface? Share this post Link to post Share on other sites
solver 1682 Posted April 7 Look at the image I posted above, and compare with yours. What's different, other than mine has no sill? Share this post Link to post Share on other sites