dskogg 24 Posted December 30, 2016 I have a different ceiling height in kitchen(taller) and when i add a invisible wall to show rooms the end of the wall has no drywall on it, when i change both rooms to same height this goes away. Is there not a way to show this correctly with different ceiling heights? David Share this post Link to post Share on other sites
Chopsaw 660 Posted December 30, 2016 You should be able to select the wall beside the fridge and use the Edit Wall Layer Intersections tool to pull back the framing layer 1/2" to expose the drywall. Share this post Link to post Share on other sites
dskogg 24 Posted December 30, 2016 thanks that was easy. Share this post Link to post Share on other sites
dskogg 24 Posted December 30, 2016 I select this tool but it wont allow me to pull back framing. what am i doing wrong? Share this post Link to post Share on other sites
Chopsaw 660 Posted December 30, 2016 Select the wall then the tool. Look for tiny diamonds for each layer. Share this post Link to post Share on other sites
dskogg 24 Posted December 30, 2016 i have selected wall first then that tool, diamonds do show up but will not allow me to drag anywhere. Share this post Link to post Share on other sites
Ridge_Runner 131 Posted December 30, 2016 Have you tried zooming in to grab them? Share this post Link to post Share on other sites
Chopsaw 660 Posted December 30, 2016 Try making your invisible wall "No Locate" in Wall Specification > General > Options. If that does not work you may want to post your plan file. Share this post Link to post Share on other sites
dskogg 24 Posted December 30, 2016 Did that still did not work, i have run into this many times before when invisible walls meet normal walls. Here is the plan to see. 4548 stanley v1.0.zip Share this post Link to post Share on other sites
solver 1636 Posted December 30, 2016 You can use a doorway. Turn off the casing change the height to match the lower ceiling. Share this post Link to post Share on other sites