SHCanada2

As someone who does most of my projects in a few hours, there was not a lot of feature changes, so far as I have played around, to improve my efficiency (except project management mode). The new project management mode is quite nice and is quicker for starting a project and using reference display sets. Showing Stairs on either level feature will be nice for garage suites and site plans as well as the walkthrough improvements, when I do them. I look forward to the webinars to see what I may have missed. There are always some good nuggets to pick up

You can drop a text box in the room with a macro. The macro is in the link above

a search for metric room area yields:

I tried that once, then the development authority told me to put them on the plans to get them approved

and if you want a dutch / reverse gable You can take dougs two roof planes above the entry door and move them using the transform replicate tool in the Z and Y directions. Then collapse the main lower roof to where it was,. and then draw a second floor wall below the gable roof planes, with the property roof cuts wall at bottom

that is handy, where today I just guess

Are you looking to put a gable there or a dormer? I dont think a dormer would fit. Post the .plan file

or use %width"W x %height%H then there is no debate

select the roof planes and go to transform replicate, move it in the z direction

in project management mode, the files are not accessible. If you want a copy you have to export it...but it is a copy

what do you want the roof to look like? Normally I will raise the roof or alter the existing roof to go over another part of a building

I've had that problem many times and thought it was just me. If you do find out what it was with the wall intersection tool, please post the solution, thanks

not sure exactly what you are trying to do, but you can set the eave width on the wall if you do not want it to protrude beyond the wall

Managed projects has multiple ways to be used based on your desired workflow. Common Documents seems to be for warehouse type template plans

I'm not sure what the purpose of the wall in the middle of the stairs is? If you delete it, it works as long as you set the attic wall to "roof cuts wall at bottom"

lower the roof planes using the transform replicate tool, or make the eave width larger

as well, if this is existing house, to be accurate you would need to know the heel height or difference in top plate to bottom of fascia If rafters, the birdsmouth depth is not certain l Below you have is that as measured from the top of subfloor on site? Typically to know for sure, one would have to go into the attic, or open up the soffit or do some math on relative heights (such as measure from top of window to eave, then measure from ceiling to top of window inside)

one side of your gable has 12" overhang while the other has 18"...not sure if that is intentional

your roof pitches are 8:12 and 3:12 when auto built: the bottom wall has it as 8:12

It still shows correct top plate. after the rebuild of the roofs, the proper way to eliminate roofs is to use the roof intersect tool. the one I modified is too big to attach, but deletde all roofs but the main tw0 over the breezeway and then, modify those 2 to meet the garage

where do you see that? I do not

Is this more what you are looking ofr 05.05.2025_13.31.15_REC.mp4

it looks like a gable above the entry would be more feasible, as It does not look like you have enough room horizontally for a dormer with more than tiny walls

I think it you detach perpendicular deck walls from the house and run a parallel deck wall to the house about a foot away, and then move it to be next to the brick and then make it invisible, it seems to work:

see attached with 2 sections, both with same elevations for top plates, then I raise the roofs on the right structure and rebuild the framing. You can see the top plate stays the same I must be missing something, you probably want to post the plan 04.05.2025_21.17.00_REC.mp4