buzzsaw204

hi,

is there a setting to turn on the handrail to display in Plan view.

my City Plan Examiner requires it to be drawn in floor plan.

Vs.

i often uses Corner Boards function.

when using it in a low pitch gable end roof, i can pull up the Boards up far enough to hide behind the facia and it doesnt show thru the roof.

but on a hight slope pitch roof, when you pull it that high,  to hide the board under the facia, it will poke thru on the roof.

is there anyway to trim or edit the CB or any other method of drawing Corner Boards??

thanks,

vs

HI,

i have a 2 story house plan with the garage on the main floor.

how can i display my both roofs (Garage Roof & 2nd Floor) at the same time on my site plan?

thanks

vs

Check out Scott's Video on double studs in a wall.

Where can I find Scott's video?

hi,

i there a way to make or build a Double Stud wall? and generate 3D framing with it?

I've built a double stud, wood frame @ 16"oc wall.

it look ok drawn in plan view, but when generateing framing for it. it doesnt work.

thnks

vs.

i cant seem to figure out how to print to Landscape on my printer, in Mac OSX

i have a HP DesignJet 130, that can print 24"wide with the paper on the roll.

the setting i want is to print is 24 x 18", Landscape, which utilizes the 24" wide paper roll and would be cutting the sheet @ 18" long.

my Layout is set up 24x18 Landscape and i have my Print Setting to Lanscape

but when it prints, it keep printing Portrait, 18" wide and 24" long

is there a setting turn off this line when a door is placed on a exterior wall??

hi,

is there a way  to change the pre-set label of the "Current Floor:" name (Foundation, 1st, Attic..) to make it your own name?  Like.....Basement, Main Floor Plan, Attic Plan.

because every time i send this view to Layout, i wouldn't have to rename the view.

thanks,

Vs.

is there a setting to have the dimension "Centered on Dimension Line" for the Terrain Perimeter dimension?

hi,

what is the setting to change the dimension unit from  Architectural (30'-7") to Engineering (30.6')

i would like to show my Terrain Perimeter dimension in Engineering units.

thanks

Vs.

i saw this hatching in the Riverstone sample drawing.

how is this done?

thanks,