Mark3D
-
Posts
486 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Posts posted by Mark3D
-
-
check second floor defaults ceiling heights the have negative height
-
to start with the deck has negative ceiling height check that try that but there is still some other problem
- 1
-
Double click the select tool
-
If you put the terrain on the floor below u should be able to have deck wall on top of terrain retaking wall I think
-
See if that is what you want you had your retaining wall on the floor below all terrain controlling data needs to be on same level as terrain perimeter but i shifted your deck wall a bit
-
See if that is what u want
-
6 hours ago, Nick29 said:
Thank you so much for taking the time to fix that up Mark that's a great starting point for me, very much appreciated.
Looking at the plan I can understand what you were saying Glenn about not having lines running through regions.
Thanks Michael for your advice too I'll see how this goes with the driveway.
Out of interest looking at the DTM layer are the intersections the points where the elevations where taken during the survey?
Out of interest looking at the DTM layer are the intersections the points where the elevations where taken during the survey?
yes i put those lines on chiefs elevation data layer and made them blue gave them a thick line weight so you would see them plus i broke them so they would not overlap elevation regions
Its is really good to have them standout when trouble shooting crazy terrain results
-
I had a very rough go at it to get you started, its rough around the edges but they will get better with terrain breaks and retaining walls, have a look at the file it should point you in the right direction
-
Have a look at this file i found your elevation data put it on correct layer made it standout blue you will see you have elevation lines ontop of elevation regions chief needs no overlap at all
Glenn beat me with this anyway the file may help you so i will leave it there
-
Try login in to your digital locker you should be able to pay there
-
see if that file helps you need to line up the base lines alter the start and end toggles
-
-
put minus sign where rotating the roof plain -31.26°
-
Check this file out I put invisible material on the railing posts and made new posts with slabs
- 1
-
have a look at this file i lowered the porch ceiling by half inch and joined the roof plans over that corner
-
There is something very strange there i can not see what is causing it
-
try copying the gable line to the front side
-
with that glitch un tick upper pitch on the skillion gable walls
-
Have a look at this file and see if it is what you want there is a little glitch in the corner where the skillion roof meets i would clean it up manually buy turning off auto roof after you have your roof right and manually adjust
-
Reply to keep current
-
this is a old thread from 2014 i have the file and it is not doing it in x13 i deleted my last reply as i did not realize it was old thread
-
upload your plan some one might do it for you
- 1
-
This is a roof that you can get 95% there with auto roof tool by changing the bedroom area roof group to 1 then most off your problem are gone with off angles and just some minor manual roof work at the end
-
My guess is you have turned off one of your snaps and you are drawing of angle, you may have turned off by mistake and forgot
Deck railing into exterior wall
in General Q & A
Posted
plan attached should be fixed
951192931_RAILINGISSUE.plan