JPG Wall Section convertion to Cadd

[DCB123]

Hello;

I would greatly appreciate it if someone would 

send me a well laid out typical wall section detail for an exterior wall 2x4

townhouse construction, down here in SW Florida. I need this in either DWG,

or Good Line software, so as it will be legible on my layout.

Thx,

 

(See Image Below)

Edited 6 hours ago by DCB123
addon

[GeneDavis]

I don't have X9 or X10, but if I did, you could Venmo me the cost of a couple of Arturo Fuente Short Story cigars, and I'd knock that out for you.

 

Or instead, you can roll your own, so to speak.  Import the image into a CAD detail, resize it to get it close to scale, draw over with Chief CAD tools, annotate with Chief text tools, and give yourself a pat on the back.  Set your stopwatch.  It should take less than ten minutes.  Five, the second one you draw like this.

[joey_martin]

Bra...you should be able to draw that detail in the time it took to create this post...