is there a way to get a plumb fascia board that has a straight bottom on a gable?

[SHCanada2]

would like it to look like the red below. I tried all the combinations under roof plane->options->eave but could not find something that does per below:

[robdyck]

Use a shadow board...gables only.

[SHCanada2]

thanks, that worked

Edited September 21 by SHCanada2

[CAmichael240114]

The "eaves" fascia or sub fascia is smaller than the gable fascia

[SHCanada2]

46 minutes ago, CAmichael240114 said:

The "eaves" fascia or sub fascia is smaller than the gable fascia

ah, are you saying that is what controls that? i.e. if I made the subfascia the same height as the fascia, then the facia board would not get cut horizontally like I show?

 

interesting