Pull handle placement on base cab trash pullout

[GeneDavis]

I know I have done this successfully before but cannot remember the method for spec.  I do a trashbin pullout (Rev-a-shelf hardware) drawer in most kitchens I model.  See the pic here.

 

 

How do I get the handle up and onto the top rail of the paneled drawerfront, instead of the center?  I cannot get a handle on it if I spec it as a door panel or drawer panel.  As shown in pic, when I spec it as a drawer (which it is), I cannot move the handle where wanted without affecting the drawer above.  If I spec it as a bottom hinged drawer, I get the handle where I want, but I don't want the opening indicator.

[PitMan71]

Gene

 

You gotta go a little deeper in the menu.

- Click on Appliance/Door/Drawer "Specify"

- Then you will see the setting you want under "Door Handle"

 

Shane

Edited Saturday at 02:57 PM by PitMan71

[GeneDavis]

 But I'd like to do it without the appliance.  I do other appliances that aren't in libraries.

[DBCooper]

Instead a a "drawer panel", try making it a "false drawer" and then you should be able to set the handle and position.

 

[PitMan71]

2 hours ago, GeneDavis said:

But I'd like to do it without the appliance.  I do other appliances that aren't in libraries.

When I do that I don't have to add an appliance. I simply change the bottom door to a single drawer, then click on "Specify" in the Appliance/Door/Drawer section and under Drawer Handle / Vertical position set the pull/handle 2" from the top.