C-Channel Pulls

[JDSScott]

I am trying to design a kitchen with C-Channel Pulls on all the base Drawer Cabinets, could someone tell me how this is done.

[5FT-20Designs]

If you have a subscription or SSA, look at the hardware Bonus catalogs.  Also Belwith-Keeler may have something close to what you’re looking for.

DOWNLOAD

123

[Adam_Gibson]

There should be some available in the 3D warehouse for Sketchup.

[MarkMc]

Depends- integrated as part of the door, custom door symbol, custom drawer box symbol, separations are a custom cabinet door placed as a side inset

 

Or as a metal channel? These were done with J channel but C can also be used (start with a molding to make the door symbol).

Adjust the Y origin and lock the height. The cabinets in this case used a traditional overlay. Takes a bit of playing around to get there. 

Note-   Perhaps can also be done with full overlay. Did these a long time ago so don't quite remember why but I had trouble changing to Full overlay just now

The sides were custom symbols Inserted in the back of the cabinet, left one exposed for reference.

 

 

 

I have some available for sale if need be. (while challenging, even frustrating, making them yourself is a good learning excercise)

[MollyNDG]

There was a good discussion on this under the symbol & content forum, worth a look. I personally prefer the method discussed by the OP of that post, but the integrated handles could be more useful in some circumstances. Instead of doing some kind of custom side (as kat_euromax is doing here), I just set sides to "none" and always have a panel on the end cabinets.