The most efficient way to raise The cabinet height of all wall cabinets by 2 inches when they are different heights?

[Renerabbitt]

What's your method?

[Gawdzira]

Block, raise, unblock.

[Alaskan_Son]

Select single Wall Cabinet, Marquee Select Similar, Select All Similar, Transform Replicate, Move 2" in Z direction, Okay.

[Renerabbitt]

7 hours ago, Alaskan_Son said:

Select single Wall Cabinet, Marquee Select Similar, Select All Similar, Transform Replicate, Move 2" in Z direction, Okay.

Sorry It was late. I meant to raise the height of the cabinet itself when you have different height cabinets
 

[Gawdzira]

I am not answering and more questions before I can speak with counsel.

[Alaskan_Son]

3 hours ago, Renerabbitt said:

Sorry It was late. I meant to raise the height of the cabinet itself when you have different height cabinets
 

 

I see.  Make all cabinets 2" taller.  I'm not sure I have a specific method for doing this in any specifically efficient way. I guess it depends on how many cabinets of different heights I have.  One way or another though I would likely just group select cabinets based on specific heights and change the heights one group at a time.  As far as selecting those groups...

 

If I immediately knew where they were, I might just manually group select, If I knew off the top what the different heights were, I might use the Match Properties tool to group select, otherwise, I might use a temp schedule to group select by height. 

[Renerabbitt]

19 minutes ago, Alaskan_Son said:

 

I see.  Make all cabinets 2" taller.  I'm not sure I have a specific method for doing this in any specifically efficient way. I guess it depends on how many cabinets of different heights I have.  One way or another though I would likely just group select cabinets based on specific heights and change the heights one group at a time.  As far as selecting those groups...

 

If I immediately knew where they were, I might just manually group select, If I knew off the top what the different heights were, I might use the Match Properties tool to group select, otherwise, I might use a temp schedule to group select by height. 

Which leads me to, we should be able to add +2 to "No Change"

[Alaskan_Son]

12 minutes ago, Renerabbitt said:

Which leads me to, we should be able to add +2 to "No Change"

Yes.  I can’t tell you how many times I’ve tried some variation of that over the years hoping that I can get it to work somehow.

[Gawdzira]

Ohh, now I remember. I add +2" to No Change and then scream an expletive.