Wall snapping preventing proper design

[westvale]

Hello friends,

 

I'm trying to draw a pony wall in a shower.  The pony wall was drawn as a railing in Chief with glass on top.  I need the wall to come beyond the end of the shower tray, where there's a glass wall perpendicular.  The pony wall needs to extend past the perpendicular wall but it keeps snapping to it.  I can either have it too far past, or not enough, but it won't allow it just a couple inches past.  What do I do?  You can see in the image that the flange of the shower tray is poking out which I'm trying to fix. 

[Kbird1]

A short room divider can sometimes help with this, seen in orange below

 

 

M.

[westvale]

I have a room divider for the shower so that I don't have baseboards in the shower.  Are you suggesting a second room divider? 

[mtldesigns]

6 minutes ago, westvale said:

I have a room divider for the shower so that I don't have baseboards in the shower

HUH?  I am not sure I understand why you have this to not have baseboards.  If the shower is a room, you can delete baseboards.  If its not a room, you can turn off baseboards on a given wall..

 

And yes to answer your question to Mick..  Use a diver to get that pop out

[Kbird1]

5 minutes ago, westvale said:

I have a room divider for the shower so that I don't have baseboards in the shower.  Are you suggesting a second room divider? 

 

Yes in that case it should work, it is the other RD that is causing it to always snap back.

 

M.

[Kbird1]

1 minute ago, mtldesigns said:

HUH?  I am not sure I understand why you have this to not have baseboards.

 

In the Shower Michael , not the bathroom , personally I have a Room type made for Showers that does not have BBs by default.

 

M.