SusanC Posted January 15, 2015 Share Posted January 15, 2015 I am drawing a master bath with a cathedral ceiling. The peak is 166". The ceiling starts at 129" on one side and 101" on the other. I'm sure there is a way to accomplish this, but I am stumped. I currently have it drawn so the ceiling starts at 129" on both sides and peaks at 166". Any advice would be much appreciated. Thank you, Susan Link to comment Share on other sites More sharing options...
Kiwideziner Posted January 15, 2015 Share Posted January 15, 2015 You need to adjust the roof plane, and hence the wall heights. Or if the roof planes have to remain as is use a manual ceiling plane. a picture would help to clarify what exactly you are aiming for. and the method reqired Link to comment Share on other sites More sharing options...
Dennis_Gavin Posted January 16, 2015 Share Posted January 16, 2015 Susan - As Graeme said select the roof plane and then using the transform replicate icon lower the Z value as needed. Then reconnect the roofs as needed. Link to comment Share on other sites More sharing options...
SusanC Posted January 16, 2015 Author Share Posted January 16, 2015 Thank you. I had a feeling it was something like that. I've built cathedral ceilings using ceiling planes before, but they were always starting at the same height. This is a partial layout of the house showing the areas we are touching. The perspective is a bit distorted, but it gets the idea across. I need the ceiling plane to start at 129" on the left side of the room and 101" on the right side of the room. The peak is 166" with a 36" flat portion of ceiling at the peak. Thanks! Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now