winterdd Posted August 13, 2021 Share Posted August 13, 2021 So, I have the posts offset at 4" but cannot figure out the option to offset the balusters too. Link to comment Share on other sites More sharing options...
Chopsaw Posted August 13, 2021 Share Posted August 13, 2021 Yea apparently chief has not figured that out yet either. Likely the easiest remedy for that situation without seeing the plan file would be to add a 4" invisible exterior layer to your railing wall definition. 1 Link to comment Share on other sites More sharing options...
robdyck Posted August 13, 2021 Share Posted August 13, 2021 It's probably best that your railing wall is as thick as the Newels. Then the railing should all be centered. That might give you an issue with the beams... 1 Link to comment Share on other sites More sharing options...
winterdd Posted August 13, 2021 Author Share Posted August 13, 2021 Thanks chop and rob. Both ways worked. The beam is even centered too. 1 Link to comment Share on other sites More sharing options...
robdyck Posted August 13, 2021 Share Posted August 13, 2021 Just now, ChiefUserBigRob said: Thanks chop and rob. Both ways worked. The beam is even centered too. Every now and then you get lucky! Link to comment Share on other sites More sharing options...
winterdd Posted August 13, 2021 Author Share Posted August 13, 2021 24 minutes ago, robdyck said: Every now and then you get lucky! I hear ya......a lot times I build the posts and beams manually because of the offsets. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now